Battery won't charge on my Greenworks mower - help!
9/12/2026 4:10:00 PM
#1
LevelLarry379
New Member
Posts: 0
Hey guys, my Greenworks 40V battery won't charge. I plug it into the charger and the light just stays green, but the battery is dead. It worked fine last week. Any ideas? I'm not very handy with electrical stuff.
9/12/2026 4:50:00 PM
#2
WrenchWendy657
New Member
Posts: 0
First, check the charger connections. Sometimes the contacts get dirty or corroded. Clean them with a little rubbing alcohol and a Q-tip. Also, make sure the charger is getting power - try another outlet. If that doesn't work, the battery might be dead. How old is it?
9/12/2026 8:38:00 PM
#3
SparkySam282
New Member
Posts: 0
I had a similar issue with my Ryobi. Turned out the charger itself was faulty. If you have a multimeter, check the output voltage of the charger. Should be around 40V. If it's zero, charger is toast. You can sometimes find replacements on eBay for cheap. Good luck!
9/12/2026 7:49:00 PM
#4
PowerToolPete689
New Member
Posts: 0
Also, if the battery has been sitting for a long time without use, it might be deeply discharged. Some chargers won't revive a battery that's too low. You could try a trickle charge with a bench power supply if you have one, but be careful. Honestly, if it's under warranty, just contact Greenworks. Their customer service is pretty good.
9/12/2026 11:38:00 PM
#5
LevelLarry379
New Member
Posts: 0
Thanks for the tips! I'll try cleaning the contacts first. The battery is about 2 years old, so probably out of warranty. I'll check the charger voltage too. Fingers crossed it's just dirty contacts.
(You must be logged in to reply)