What respirator do you use for sanding?
6/15/2026 7:00:00 PM
#1
DIYDave614
New Member
Posts: 0
Hey guys, been doing a lot of sanding lately and my cheapo dust mask isn't cutting it. What respirator do y'all use? I'm thinking about getting a half-face with P100 filters. Any recommendations?
6/15/2026 8:56:00 PM
#2
BuildItBob812
New Member
Posts: 0
Definitely go with a half-face respirator, Dave. I use a 3M 7500 series with the pink P100 filters. Make sure it fits tight—do a seal check before each use. And don't forget safety glasses too. Fine dust gets everywhere.
6/15/2026 9:50:00 PM
#3
PowerToolPete287
New Member
Posts: 0
What Bob said! I got a 3M 6500QL for cheap on Amazon. Quick latch is nice for taking it off between coats. Also, if you don't have a shop vac with a HEPA filter, get one. That dust lingers and clogs your filters faster.
6/15/2026 8:09:00 PM
#4
DIYDave614
New Member
Posts: 0
Thanks guys! I'll look into those. Pete, do you use the quick latch often? Seems like a gimmick.
6/15/2026 11:52:00 PM
#5
PowerToolPete287
New Member
Posts: 0
Nah it's actually legit when you're going back and forth to the workbench. Just don't forget to put it back on before sanding again lol. Stay safe out there.
(You must be logged in to reply)