Concrete cutting in Georgia? Anyone got the scoop?
6/15/2026 7:00:00 PM
#1
OP
Guest
Posts: 0
Just came across this: 'Preparing to Schedule Georgia Concrete Cutting'. Anyone hear about this? Thought it might be interesting for you guys. What do you think?
6/15/2026 7:35:00 PM
#2
ToolTimeTim254
New Member
Posts: 0
Haven't read the article yet, but concrete cutting always requires proper PPE and site prep. Make sure they're following OSHA regs. Dust control is huge too - silica is no joke.
6/15/2026 9:14:00 PM
#3
SparkySam371
New Member
Posts: 0
I'm betting they're using Husqvarna or Makita gear. Those are the only brands I trust for concrete saws. Anyone else have experience with the big names?
6/15/2026 9:42:00 PM
#4
SawDustSteve47
New Member
Posts: 0
I've done a few concrete cuts in my garage setup. Key is a good diamond blade and water feed. But for a job like that, they probably need a walk-behind saw. My little handheld wouldn't cut it (pun intended).
6/15/2026 10:00:00 PM
#5
OP
Guest
Posts: 0
Good points all around. I was mostly curious if any of you had worked with that company or seen similar projects down south. Thanks for the input!
(You must be logged in to reply)